Scissor lift
Key Dates
Due Date
-
Posted Date
-
Agency & Value
Agency
W6QM MICC-FT DRUM
Contract Value
Not provided
Codes & Classification
Solicitation Number
W911S226U3296
NAICS
333120 - Construction Machinery Manufacturing
Classification Code
3895
Additional Details
The Department of the Army, through the Mission and Installation Contracting Command at Fort Drum (W6QM MICC-FT DRUM), has issued a Combined Synopsis/Solicitation for the procurement of an Electric Slab Scissor Lift. This opportunity, identified under procurement number W911S226U3296, is classified under NAICS code 333120 (Construction Machinery Manufacturing) and Product Service Code 3895. The solicitation is set aside for Small Business Administration (SBA) participants, reflecting the agency’s commitment to supporting small business engagement in federal procurement.
The primary objective of this procurement is to acquire a high-performance, narrow-width electric scissor lift designed for both indoor and outdoor use in confined spaces. The specified equipment must be powered by a 24V DC electric drive, ensuring zero emissions and making it particularly suitable for indoor environments where air quality and noise are concerns. A key requirement is the lift’s narrow 32-inch width, which enables maneuverability in tight areas without sacrificing operational capability.
The scissor lift must meet the following critical specifications: a maximum working height of 37 feet 7 inches, a platform height of 31 feet 7 inches, and a lowered platform height of 51 inches. The overall dimensions include a width of 32 inches, a length of 91.6 inches, and a stowed height (with rails up) of 94 inches. The platform itself measures 83 inches by 27.5 inches and features a 3-foot roll-out extension deck, supporting flexible access for operators. The equipment must support a total capacity of 550 pounds, with the main platform rated for 300 pounds and the extension deck for 250 pounds, accommodating up to two persons.
Operational performance is defined by a gradeability of 25%, an inside turning radius of 43 inches, and an outside turning radius of 104 inches. The lift and lower cycles are required to operate within 55–60 seconds and 47–55 seconds, respectively, under rated load. Drive speeds are specified at 2.0 mph when stowed and 0.5 mph when raised, with the ability to drive at full extension height. The lift must be equipped with solid, non-marking tires (16 x 5 x 12) to protect indoor flooring and ensure durability.
Safety and operational features are integral to the requirement. The lift must include a variable speed electric drive, dual holding brakes, proportional controls, pothole protection, tilt sensor and alarm with drive/lift cut-out, all-motion audible alarm, and an overload sensing system. Platform amenities include a 110V AC outlet with GFI, a half-height spring-hinged entry gate, fold-down hinged railing, and lanyard attachment points for fall protection. Maintenance and transport features such as an on-board diagnostic interface, low voltage battery protection, tie-down and lift lugs, and forklift pockets are also required.
The procurement is managed by the Department of Defense, Department of the Army, with Kevon Williams serving as the primary point of contact ([email protected], 270-461-3884). The notice was posted on May 22, 2026, with responses due by June 1, 2026. The opportunity remains active and is accessible via the official SAM.gov portal at https://sam.gov/opp/a9edfca69de34c1c8923b90d9fef952c/view.
Contractors considering this opportunity should ensure their offerings meet all dimensional, operational, and safety requirements as outlined, and that they are eligible under the SBA set-aside. The procurement seeks a reliable, emission-free solution that enhances operational safety and efficiency in restricted-access environments, supporting the Army’s ongoing facility maintenance and operational needs.