Camp Natural Bridge Griddles

Key Dates
Due Date

-

Posted Date

-

Agency & Value
Agency

W6QM MICC-FT DRUM

Contract Value

Not provided

Codes & Classification
Solicitation Number

W911S226U3201

NAICS

333241 - Food Product Machinery Manufacturing

Classification Code

7310

Additional Details
Set Aside

SBA

Place of Performance

-

SourceSAM
The Department of the Army, through the Mission and Installation Contracting Command at Fort Drum (W6QM MICC-FT DRUM), has issued a combined synopsis/solicitation for the procurement, delivery, removal, and installation of heavy-duty propane gas griddles at Camp Natural Bridge, located at West Point, New York. This procurement is classified under NAICS code 333241 (Food Product Machinery Manufacturing), with Product Service Code 7310, and is set aside for Small Business Administration (SBA) eligible contractors. The primary objective of this solicitation is to replace existing griddles with new, high-performance propane gas griddles that meet rigorous specifications suitable for institutional food service environments. The scope of work encompasses the removal of current griddles, delivery of new units, installation, and start-up on the first floor of the designated building at Camp Natural Bridge. Key requirements for the griddles include: - Heavy-duty construction with a stainless steel front, sides, and front top ledge, as well as a fully welded stainless and aluminized steel chassis frame. - An 11-inch low-profile cooking height, supported by 4-inch adjustable legs. - A 1-inch thick polished steel griddle plate, complemented by 12-gauge, 10-inch stainless steel back and tapered side splashes for enhanced durability and ease of cleaning. - A spatula-wide, 3-1/2 inch grease gutter and chute, fully welded to prevent grease migration and facilitate maintenance. - Each griddle must feature one 27,000 BTU/hr U-shaped aluminized steel burner for every 12 inches of griddle width, with an embedded snap-action thermostat per burner. Temperature controls must allow adjustment from 200°F to 550°F (steel or chrome plate) or 200°F to 450°F (rapid recovery plate). - Large 6-quart stainless steel grease drawers (two drawers required for 60-inch and 72-inch models). - Heavy-duty chromed thermostat knob guards and one pilot safety valve for every two burners, ensuring that propane gas is completely shut off if the pilot is extinguished. - Manual ignition, bottom heat shields, a ½-inch rear propane gas connection, and a propane gas pressure regulator are required for each unit. - The griddles must operate on propane gas at 10.0 inch (254 mm) water column pressure. The contractor is responsible for all aspects of removal and installation, including ensuring proper connection and start-up of the new griddles. All work will be performed on the first floor of the specified building at West Point, NY. This opportunity is open exclusively to SBA-eligible small businesses. Interested parties should note the active status of the notice and the relatively short response window, with proposals due by May 15, 2026, at 17:05. The primary point of contact for this solicitation is Jason Lewis, who can be reached at [email protected] or by phone at 520-687-8216. Contractors considering this opportunity should ensure they have the capability to provide, deliver, and install commercial-grade propane griddles that meet the detailed technical specifications, as well as the capacity to remove existing equipment and perform installation in a secure, federal facility. The procurement is governed by the terms and conditions set forth by the Department of Defense and the Department of the Army. Further details and updates can be accessed via the official SAM.gov opportunity posting at https://sam.gov/opp/8348909055d14944ab99fcecce146205/view.