TSS Ductless System at EWR ATCT - Amendment 04
Key Dates
Due Date
-
Posted Date
-
Agency & Value
Agency
697DCK REGIONAL ACQUISITIONS SVCS
Contract Value
Not provided
Codes & Classification
Solicitation Number
TSS_Ductless_System_at_EWR_ATCT
NAICS
238220 - Plumbing, Heating, and Air-Conditioning Contractors
Classification Code
Z1BA
Additional Details
The Federal Aviation Administration (FAA), under the Department of Transportation, has issued a solicitation for the installation of a ductless mini-split HVAC system at the Newark Air Traffic Control Tower (EWR ATCT) in New Jersey. This procurement, managed by the 697DCK Regional Acquisitions Services office, is classified under NAICS code 238220 for Plumbing, Heating, and Air-Conditioning Contractors, and is set aside for SBA-eligible businesses.
The scope of work encompasses comprehensive mechanical, electrical, controls, and structural/interior tasks to ensure the successful installation and integration of the new ductless system. Key mechanical requirements include the installation of three indoor wall-mounted units, all associated refrigerant and drain piping, and a 6-ton heat pump anchored to the exterior concrete wall using an L-bracket steel frame. The contractor will be responsible for coordinating core penetrations through the concrete wall for piping, electrical, and drain lines, ensuring all wall waterproofing is addressed. All refrigerant and condensate piping above the ceiling must be properly insulated, and the system must be tested and charged to verify operational readiness.
On the electrical side, the contractor must install a dedicated 208V, 3-phase power circuit, provide a NEMA 4X, 60A non-fused stainless steel disconnect at the outdoor unit, and ensure all power and control conduit and wiring are routed to and from all units. This includes penetrating the concrete wall and providing conduit through the roof deck, with all roof work patched and flashed as required to maintain the existing Carlisle roof warranty.
For controls integration, the mini-split system must be tied into the FAA’s existing Schneider Electric EcoStruxure DDC system via BACnet. The contractor will provide and install an IP-IO module at VAV-17 for coordinated backup cooling enable/disable, submit a point list, graphics, and control narrative for approval, program unit set points, update AHU-3 supply air setpoints, and support system commissioning to validate operation.
Structural and interior work includes concrete core penetrations for pipes and conduits, installation of support framing and steel plates as detailed in the drawings, and provision of supports for all pipes and conduits. The contractor is also responsible for wall restoration and painting upon completion of the installation.
A site visit is scheduled for March 17, 2026, at 3:00pm EST, with a secondary session at 5:00pm EST if needed. Interested firms must notify the Contracting Officer, Elisha Distler, at [email protected] by March 11, 2026, 5:00pm CST, and attendance is limited to three individuals per firm.
The solicitation has undergone several amendments, including the provision of updated documents, site visit information, and a final Q&A document with corresponding imagery. The final proposal due date is set for April 30, 2026, at 5:00pm EST.
This opportunity is ideal for contractors with demonstrated experience in HVAC system installation, electrical integration, and controls programming, particularly within secure or mission-critical environments. The project location is in New Jersey, United States, and all work must comply with FAA standards and maintain the integrity of existing building systems and warranties.
For further information or to submit questions, contractors may contact the primary point of contact, Elisha Distler ([email protected], 817-222-4196), or the secondary contact, Robert Higgins ([email protected], 781-238-7670). Full solicitation details and attachments are available on SAM.gov under Opportunity ID b688b6a803724b1a95ae03855fc87037.
Contractors are encouraged to review all solicitation documents and amendments to ensure compliance with requirements and to determine alignment with their technical capabilities and business qualifications.
Documents19