Standby Generators
Key Dates
Due Date
-
Posted Date
-
Agency & Value
Agency
W6QM MICC-FT DRUM
Contract Value
Not provided
Codes & Classification
Solicitation Number
W911S225U1695
NAICS
335312 - Motor and Generator Manufacturing
Classification Code
6115
Additional Details
This procurement notice, issued by the Mission and Installation Contracting Command at Fort Drum (W6QM MICC-FT DRUM), seeks to secure the supply and installation of standby generator systems under a combined synopsis/solicitation (Procurement Identifier: W911S225U1695). The requirement is classified under NAICS code 335312 (Motor and Generator Manufacturing) and Product Service Code 6115, with the opportunity set aside for SBA-eligible businesses.
The primary objective of this procurement is to obtain two dual-fuel standby generator sets—one rated at 60 kW and the other at 80 kW—along with all necessary enclosures, accessories, and automatic transfer switches, from a single supplier. The intent is to ensure a complete, code-compliant, and fully operational backup power solution for the designated facility. The generator sets must be factory-built, production-tested, and site-tested, and must include all components required for a turnkey installation as detailed in the project specifications and drawings.
Key requirements include:
- Provision of one 60 kW and one 80 kW dual-fuel standby generator, each configured for 120/208V, 3-phase operation with a 400-amp main.
- Both generator sets must feature NEMA 3R-rated enclosures, be EPA Tier 5 certified, and be suitable for use with natural gas (no fuel tanks required, as natural gas is available onsite).
- Each generator must be supplied with a battery and battery charger.
- Automatic Transfer Switches (ATS) for both units must be NEMA 3R-rated, service entrance rated, and capable of standard, programmed, closed transition operation.
- Standby startup and load banking are required for both units.
- All equipment must be new, current production, and sourced from a manufacturer with single-source responsibility for warranty, parts, and service, supported by factory-authorized representatives and factory-trained technicians.
The supplied systems must comply with all applicable codes and standards, including but not limited to:
- National Electrical Code (NFPA 70), specifically Articles 700, 701, and 702
- NFPA 110 (Level 1 Emergency and Standby Power Systems)
- CSA C22.2 No. 14-M91, EN50082-2, EN55011, IEC 8528 Part 4, IEC 61000-2/3/6, and IEEE 446
The procurement explicitly requires that Level 1 prototype tests, as defined by NFPA 110, have been performed on a complete and functional unit; component-level type tests are not acceptable substitutes.
The contracting office has clarified that the receiving facility is equipped with a forklift, so no offloading services are required from the supplier. All exceptions to the published specifications are subject to approval by the governing agency.
Interested SBA-eligible contractors with expertise in generator manufacturing and installation are encouraged to review the full solicitation and ensure compliance with all technical and regulatory requirements. The point of contact for this opportunity is Damian Haye ([email protected], 706-505-4360). The notice remains active, with responses due by September 2, 2025.
Further details and updates can be accessed via the official SAM.gov listing at: https://sam.gov/opp/5931b4a4d46d485ba8293aa25885b4c8/view.